Article · 1985

The Kyrenia Ship: An Interim Report on Its Hull Construction

J. Richard Steffy

American Journal of Archaeology 89(1) 71-101. Archaeological Institute of America

An article on the construction, surviving timbers, repairs and reconstructed hull lines of the Greek merchant ship wrecked off Kyrenia in the late fourth century BCE.

Steffy describes the surviving hull of the Kyrenia ship, excavated off the north coast of Cyprus, and reconstructs how it was built, repaired and altered. The report moves from the individual hull components to an interpretation of construction sequence, repairs and hull form. It condenses a much larger hull catalogue compiled by Helena Wylde Swiny, and the rigging, the steering and the reconstructed hull studies are treated elsewhere.

The evidence

The components are taken in turn: keel, stem, planking, frames, ceiling, beams and the mast-step complex, each described through measurements, tool marks, joints, nail positions and the condition of the timber. Tables set planking dimensions, scarf joints, mortise-and-tenon spacing and the positions of watercourses side by side. Sampled timbers were identified as pine or oak, and the fittings Steffy examines include a wooden bow sheathing, the lead sheets over the hull, a keel repair block, replacement planks and a replaced frame (pp. 72–87).

The argument

Steffy argues that the ship was built shell-first. Keel and posts were joined first, then the bottom planking, floor timbers, side planking, frames and interior timbers. The frames did not touch the keel, the port and starboard hull shapes differ, and some planks could not have been fitted around frames already standing (pp. 89–91).

Temporary bracing, he proposes, held the planked shell in shape during construction, while selected naturally curved timbers and shaped planks helped form the hull. The wreck retained the full keel, more than half the stem and extensive outer planking; Steffy reconstructs the planks as joined edge to edge with pegged mortise-and-tenon joints, and the frames were nailed to the planking and stood clear of the keel. Fastening and repair traces let Steffy separate the original work from later alterations, though he acknowledges that parts of the stem and of the repair sequence remain uncertain.

The alterations he identifies are a relocated mast step, a bilge sump, a replaced frame, bow repairs and the lead sheathing (pp. 95–99). Artefactual analysis and laboratory dating place the sinking in the last decade of the fourth century BCE, and Steffy states that the interval between launch and sinking cannot yet be set precisely.

What it records

  • The Kyrenia shipwreck lay about 1 km off the north coast of Cyprus, near Kyrenia, at a depth of nearly 30 m.p. 72
  • An international team of nautical archaeologists under Michael L. Katzev excavated the Kyrenia wreck in 1968 and 1969.p. 72
  • The ship's cargo included approximately 400 amphoras of more than eight types.p. 72
  • Artefactual analysis and laboratory dating indicate that the Kyrenia ship sank in the last decade of the fourth century BCE.p. 72
  • Nearly 6,000 wooden fragments were catalogued, photographed, drawn full-size and preserved in polyethylene glycol 4000.p. 72
  • The keel was hewn from a single log of Aleppo pine and survives for its entire length, recovered in 16 pieces.p. 72
  • The outer planking had nine strakes of bottom planking on each side between the keel and the lowest wale.p. 77
  • Sheets of lead, 1 mm thick and 1.05 to 1.23 m wide, covered the entire outer surface of the hull.p. 83
  • F. Kukachka and R. C. Koeppen of the United States Department of Agriculture identified the wood samples.p. 87
  • Steffy finds firm evidence that the ship was altered several times and hauled out at least twice for major repairs.p. 99
  • Steffy projects the ship's length at about 14 m and puts its maximum breadth at about one-third of its length.p. 100

Where to read

  • Wreck discovery, excavation and hull preservationp. 72
  • Keel, stem and outer planking measurementspp. 72–83
  • Frames, ceiling, beams and mast-step complexpp. 84–95
  • Construction sequence and shell-first interpretationpp. 89–94
  • Repairs, overhaul and lead sheathingpp. 95–99
  • Hull lines and construction conclusionspp. 99–101

Contents

  • The Ship72
  • The Hull Remains72
  • The Keel72
  • The Stem76
  • Planking77
  • Frames84
  • Analysis of Timbers?87
  • Summary of Catalogue87
  • Interpretation of Hull Remains87
  • Installing the Garboards90
  • Completing the Bottom91
  • Erecting the Sides93
  • Internal Construction95
  • Repairs and Overhaul95
  • Hull Analysis99
  • Conclusions100

Objects published here

2
  • Cypriot clay model of a ship, cited as a contemporary parallel, Cesnola collection, Metropolitan Museum of Art, Inv. No. 74.51.1752 (p. 88)
  • Timber UM36, believed to be a spare steering oar blade, aft of the stern, UM36, ill. 13 (p. 86)

People, places and institutions

People

Institutions

Places

  • Kyreniashipwreck site and reconstructed ship
  • Kyrenia's Crusader Castlesite of the reconstructed ship

Also named: F. Kukachka, R.C. Koeppen, United States Department of Agriculture, University Museum of the University of Pennsylvania, Oberlin College, Texas A&M University, Metropolitan Museum of Art, Royal Botanic Gardens, Kew.

Extent pp. 71–101, ills 1–20, 1 pl.

Defines mortise-and-tenon joint, garboard strake, frame, half-frame, false keel, keelson, wales, treenail, scarf, strake, limber boards, limber holes

Cypro-ClassicalSeafaringTechnologyTradeChronology and Dating

Cited on Ancient Cyprus

1 page

People it is cited for

5 people

Institutions it is cited for

1 institution

Corrections and additions

Know this document?

Help us cite it fully and point readers to a copy.

We would like to hear about

  • The full citation, or a correction to ours
  • Where a copy can be read or downloaded
  • Missing parts, volumes or plates
  • Related documents

Tell us if you would like to be thanked by name on the page.